![]() So there you have it! Our ultimate guide to splicing coaxial cable, with and without using connectors. The electrical tape will also make the whole thing waterproof. Step 6: Cover up the entire soldered joint with electrical tape for better conductivity. Step 5: Solder the wire mesh to each other Step 4: Pull back the wire mesh towards the tip from both sides ![]() You can cover the solder with some electric tape as well for further insulation. Step 2: Cut a little bit of the insulator at the tips to expose the copper wireĭoing this will allow the wire to be overlapped when it is connected. Push the wire mesh as far back (away from the severed ends) as it will go. Strip off the rubber shield until a couple of inches. Step 1: Use the knife to strip off the rubber shield of the coax cable All you need to splice a coax cable is a sharp knife and a soldering iron! Here’s how you do it: If you want to repair your splice without any commercial equipment, or if you can’t get them at the moment, this part of the article is for you. How to splice coaxial cable without connectors Make the collar of the cable connector tight onto the barrel connector to complete splicing. Insert each cable into the barrel connector such that the protruding copper wire goes into the female connection ports present on both sides.Repeat the same with the other end of the coax cable as well.All you have to do is insert the coax cable (with the compression connector) and press hard until the connector crimps to the wire. It works with a variety of coax cables.Repeat the same with the other end of the coax cable. ![]() The copper wire should still be protruding out of the connector.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |